To access some of your phones settings you may need to login to the Cisco web interface - do this by following the step by step instructions below: 

1. Firstly you will need to find your IP address from your Cisco phone please do the following: 

Cisco SPA502G, Cisco SPA504G, Cisco SPA508G, Cisco SPA509G, Cisco SPA512G, Cisco SPA514G:

a. Press the Setup button as shown below:

b. Scroll to network and press select

c. Scroll to View Current IP. This is the IP address of your phone

Cisco SPA501G: 

a. Press the Setup button

b. Enter 110, then press #

c. The IP address is recited

Cisco SPA300 series:

To find the IP address on a Cisco SPA 300 series phone please press the Set Up button and then press 9 which will provide you with the IP address of your phone.

2. Enter the IP address into the address bar of a web browser - you will then be taken to the Cisco Configuration Utility page as shown below: 

3. If you are not please check your IP address - try removing the last 'digit' from the address 

4. If see a login window asking you for a user name or password enter this.  (The default settings should allow you to login without the use of a username or password). 

From here you can click on the 'Advanced' link in the top right-hand corner to access the Settings tab to view the settings of your phone. 

For assistance please contact our Support Helpdesk.